9/11/2001 - NYFD, NYPD, NYPA - Some Gave All

Sundays 8/7 c on ABC

THIS MONTH'S SAFETY TOPIC: 
New Propane Safety Requirements for propane cylinders

Re-printed from the NFPA website.

NFPA Fact Sheet
Propane cylinder Overfilling Prevention Devices (OPD)

An Overfilling Prevention Device (OPD) is a safety device incorporated into the filling valve of a propane cylinder (i.e., those used on gas grills, RVs, etc.). The device shuts off the flow of gas to a cylinder after 80% capacity has been reached. This limits the potential for release of gas when the cylinder is heated, averting a fire or possible injury.

Facts & Figures

	As of April 1, 2002, OPDs are required on all propane cylinders between 4 and 40 pounds propane capacity, per the 1998 edition of NFPA 58, Liquefied Petroleum Gas Code. Cylinders of this size manufactured after September 30, 1998, were required to have an OPD. A typical gas grill cylinder holds about 20 pounds of propane.
	Propane cylinders with OPDs can be identified by a triangular hand-wheel (pictured right). Some earlier model cylinders were produced with a round hand-wheel but "OPD" is stamped on the brass valve body.
	After April 1, 2002, propane cylinders not equipped with an OPD must be retrofitted with the device before refilling can occur or properly disposed of and replaced with an OPD-equipped cylinder.
	Many propane dealers will retrofit older cylinders with an OPD. As there is a charge for this, it may be more economical to replace the entire cylinder, especially if it is rusty. In many parts of the U.S., exchange cylinder racks can be used to swap an empty cylinder without an OPD for a full cylinder equipped with an OPD, for a nominal fee, eliminating the need to dispose of the cylinder or to have it retrofitted.
	Dispose of propane cylinders safely. Questions about safe disposal should be answered by local fire departments, hazardous waste collection sites, or propane refillers.
	The 2001 edition of NFPA 58 modified requirements to exempt horizontal cylinders manufactured before October 1, 1998, from requiring OPDs. Also exempt are cylinders used for industrial trucks, industrial welding and cutting gases (these cylinders must be labeled with their use).

Updated: 3/02

[ Home ] [ Up ] [ Smoke Detectors ] [ Fireworks Safety ] [ Summer Safety ][ Photo Gallery][ Links ]

Send mail to Rick Harrison with questions or comments about this web site.
Last modified: March 12, 2008
Copy Right© 2004 - BUECHELFIRE.COM, All Rights Reserved